Bluetooth signal amplification receiving and sending details

2 months ago

Bluetooth signal amplification receiving and sending details

Posted byzhangx35 points 3 replies

0 upvotes

I add a signal amplifying circuit for da14585, which needs mode switching (GPIO control) during its transmitting and receiving. However, the specific transmitting and receiving position is not found in the SDK. I don't know how to start. I hope you can give me your advice. Thank you very much. (including GPIO control when switching between broadcast intervals). sdk v_ 6.150.2

Hardware

2 months ago

PM_Dialog

Hi zhangx,

Thanks for your question on our new support forum. As far as I understood, you have a custom board and you are trying to implement a range extender application. Is this correct?

Please take a look at the following document :

//www.xmece.com/sites/default/files/um-b-089_da14585_range_extender_reference_application_v1.1.pdf

If I misunderstood your question, please clarify it and provide more details.

Can you also indicate the SDK version? Is it the DSPS or any SDK6 example?

Thanks, PM_Dialog

Log inorregisterto post comments

2 months ago

zhangx 35 points

Hi,

Thanks for your reply., it's realy what i want .

I read the pdf, but can't find a compatible SDK. Such as I can't find the "range_ext_api.h" inSDK6.0.14.1114or DA14585_SDK_6.0.10.511_0 what the pdf mentioned.

Can you provide a SDK include the range extender reference application or give me a link?

Tanks again, and look forward to your favourable reply.

Log inorregisterto post comments

2 months ago

PM_Dialog

Hi zhangx,

Apologies for the delay. Please check the Range Extender resource at :

//www.xmece.com/products/bluetooth-low-energy/range-extender#tab-field_tab_content_resources

Thanks, PM_Dialog

Log inorregisterto post comments