无法闪现哒祝福模块14580 own design board

⚠️
Hi there.. thanks for coming to the forums. Exciting news! we’re now in the process of moving to our new forum platform that will offer better functionality and is contained within the main Dialog website. All posts and accounts have been migrated. We’re now accepting traffic on the new forum only - please POST any new threads at//www.xmece.com/support. We’ll be fixing bugs / optimising the searching and tagging over the coming days.
2 posts / 0 new
Last post
Thu, 2020-05-28 19:18
#1
HarishKumar
Offline
Last seen:8 months 1 week ago
加入:2020-02-17 06:31
无法闪现哒祝福模块14580 own design board

Hi everyone,

We are facing a high priority issue. We are not able to flash into our own design board(DA14580)

By using Segger J Link lite, we made connections

J link 7th pin - SWDIO of Design Board

J link 9th pin - SWCLK of Design Board

J link 20th pin- GND of Design Board

We are trying to flash into SPI flash memory of the design board using SWD interface. After opening connected J link in Smart Snippet toolbox getting error

"No known chip found while opening JLink connection. Terminating process..."

How to overcome this? Please Consider this as aHigh Priority.

Regards,

Harish

Device:
DA14580
Fri, 2020-05-29 10:47
PM_Dialog
Offline
Last seen:12 hours 27 min ago
工作人员
加入:2018-02-08 11:03
Hi HarishKumar,

Hi HarishKumar,

Could you please indicate if you are using any of our DKs in order to program your custom board through JTAG? Or you are using an external JTAG?

Are you able to download firmware into System-RAM through Keil IDE using JTAG? Can you have the debugger attached and step in your code?

What is the version of SmartSnippets Toolbox (SST) that you are using? Could you please provide some screenshots?

Thanks, PM_Dialog