DA14585 | Dialog Semiconductor customer support - 亚博全网,亚博电竞菠菜,亚博国际官网平台网址

FINETGTIMINT not been cleared, resulting in broadcast exception

Forums:

Dialog Smartbond Bluetooth Low Energy – Software

The parameter has set the ADV_FOVEVER, but the device may stop broadcasting abnormally after two or three days (it has not been operated during this period). I checked the ble related registers, compared with the normal device, found BLE_ INTCNTL_ ,This bit in reg is set to 1, and the normal broadcast one is 0. I calledea_finetimer_isr()or software write 0, both can make abnormal device broadcast recovery. What is the cause of this phenomenon? Is rwble_isr（）not triggered? how to slove it? Thank you!~

No PWM output fro sky66111

Forums:

Dialog Smartbond Bluetooth Low Energy – Software

Hi,dialog:

I have intergrated the sky66111 follow the document um-b-089_da14585_range_extender_reference_application_v1.1 but the power have not improved, there is no pwm output at PORT2_PIN1.
The method "timer0_conf_start" is execute on debug mode.

Is something else todo?

Prod_Test Binaries Not Working on Dev Board JTAG?

Forums:

Dialog Smartbond Bluetooth Low Energy – Hardware (device & reference designs)

Hi,

I have DA14585 Dev Kit, and am loading the prod_test binaries for RF testing: ...6.0.14.1114\binaries\da14585\prod_test.

When I got to RF Master, and select JTAG, it appears the binaries are flashed to the dev board.

However, when I select continious TX we do not set any output in front of a spectrum analzyer.

Is there a reason flashing prod_test_585.hex to the dev board through JTAG would not work wth RF Master like this?

FCC Radio Testing SmartSnippets Setup?

Forums:

Dialog Smartbond Bluetooth Low Energy – Tools

Hi,

I have built a DA14585 BLE product, and in the past have seen that SmartSnippets Studio and what looks like some custom hex (flashed over UART) was used to run FCC radio testing?

What type of software and methods are available for to run the DA14585 through FCC certification testing?

uart debug issue in rcu project

Forums:

Dialog Smartbond Bluetooth Low Energy – Software

In RCU project running on DK-PRO, I want to print my own debug messages via UART when I press a button on the keyboard, but I cannot print. can I configure the DK-PRO in UART mode and in SPI mode at the same time and how! which function does the keyboard scan where I can add logs

DA14585uart

Forums:

Dialog Smartbond Bluetooth Low Energy – Software

嗨

I'm trying to use serial port to output 4000 bytes at a time, but I can't output complete and correct data. When the data is greater than 256 bytes, the following data will become garbled。

What's wrong with my settings? The device I use is da14585, and the SDK is 6.0.12 ble_ app_ peripheral

thank you

How to reduce the space occupied by sdk6

Forums:

Dialog Smartbond Bluetooth Low Energy – Software

Hello
When we used da14585 to develop, we encountered the problem of insufficient chip resources (RAM). Is there some way to reduce the space occupied by sdk6 itself in order to accommodate more of my user programs?
In addition, I feel that the space (RAM) occupied by sdk6 in demo empty_peripheral_template is more than the resource (RAM) occupied by sdk5, right?